Buickman58 Posted February 1, 2019 Report Share Posted February 1, 2019 Hello, I picked up an odd ball M1 the other day in my travels. It is a low serial number (10k) and has a maching upper and lower. The gun is saw cut and only had the lower and upper, no barrel or bolt. It has some differences from my other M1s in that the lower will not accept Thompson mags(groove too small). The upper(sorry not home to take a picture) has three holes tapped for a machine thread in front of the mag area on the bottom. also at the top of the mag area there is a a continuation of the groove into the receiver. What guesses do you guys have on what this is? The lower is exact measure to the other M1 lower I have beside it( my picture is off) Kind regards,Brock Link to comment Share on other sites More sharing options...
BillyDixon Posted February 1, 2019 Report Share Posted February 1, 2019 looks like slot for mag. has been welded up and re machined .some ones project for a different mag ?? just sayn. Link to comment Share on other sites More sharing options...
reconbob Posted February 2, 2019 Report Share Posted February 2, 2019 (edited) If the trigger frame has the engraving - i.e. FIRE, SAFE, etc. then someone has heavilymodified an original for who knows what reason. But, since the T-slot for the magazine has not beenmachined yet (I do not think it was welded up.) I think this is just some guys attempt to makea trigger frame for who-knows-what reason. People have been tinkering with Thompsons for over 50-60 years now attempting to doall sorts of things. Years ago before people starting importing parts sets there were no triggerframes available and people attempted to make them. Some succeeded and many did not. Bob Edited February 2, 2019 by reconbob Link to comment Share on other sites More sharing options...
Buickman58 Posted February 2, 2019 Author Report Share Posted February 2, 2019 Here are the receiver pictures. Just wanted to make sure I am not going to machine a lower that was something special. Thanks for the looks! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now