Jump to content


Photo

ANM2 backplate buffer section dimensions


  • Please log in to reply
3 replies to this topic

#1 bigbore

bigbore

    Regular Member

  • Board Benefactor
  • 218 posts
  • Gender:Male
  • Location:NW OH
  • Interests:WWI/II MGs

Posted 30 May 2020 - 01:49 PM

Anyone know the dimensions ? Is it the same size as a 1919, sans the pistol grip?
  • 0

#2 bigbore

bigbore

    Regular Member

  • Board Benefactor
  • 218 posts
  • Gender:Male
  • Location:NW OH
  • Interests:WWI/II MGs

Posted 30 May 2020 - 03:44 PM

“Buffer tube”
  • 0

#3 Grasshopper

Grasshopper

    Long Time RKI Member

  • Board Donor
  • 302 posts
  • Gender:Male
  • Location:Sunny Florida
  • Interests:Engines, Tractors(old, rusty is better), mechanisms, and the occasional MG

Posted 31 May 2020 - 12:24 PM

Hi Bigbore,
 
I hope this is helpful.  Measurements are as measured with a caliper likely only good to +/- 0.001".
 
Enjoy,
 
Grasshopper

 

Attached File  backplate_dimensions.JPG   166.91K   13 downloads


  • 0

#4 bigbore

bigbore

    Regular Member

  • Board Benefactor
  • 218 posts
  • Gender:Male
  • Location:NW OH
  • Interests:WWI/II MGs

Posted 31 May 2020 - 12:38 PM

Hi Bigbore,
 
I hope this is helpful.  Measurements are as measured with a caliper likely only good to +/- 0.001".
 
Enjoy,
 
Grasshopper

 

attachicon.gif backplate_dimensions.JPG


Perfect, thanks.  Same size as the buffer tube of a 1917, so I can start fitting a stock for my Stinger build.

Attached Files


Edited by bigbore, 31 May 2020 - 05:12 PM.

  • 0