Tash329 Posted September 15, 2004 Report Share Posted September 15, 2004 When replacing the the Karr M1A1 bolt with the orginal M1 bolt, are any modifactions required? Thank Rich Link to comment Share on other sites More sharing options...
Bill in VA Posted September 15, 2004 Report Share Posted September 15, 2004 Nope, none, the bolts don't interchange between the Kahr 1927M1 rifle and teh M1 SMG. It's been awhile since I've been inside a semiauto, but this is what I remember... For one thing, the semiauto bolt, whether for the 1927A1 or 1927M1 is the same bolt. The "actuator"/charging handle fits into a hole either on the top or side (semi bolt has both holes.) Plus, the recoil mechanisms between the two are different (two springs vs one). Also, the firing mechanism is different. The semiauto has a third spring that releases a "Z" shaped striker to drive a stele "pellet" (Kahr calls it a hammer) into the back of the firing pin. This whole arrangement runs through teh semi bolt. (The full auto M1 bolt has a different set up, with no provison for the "Z" and pellet.) Lastly, (IIRC) the fullauto bolt is about a tenth of an inch taller than teh semiauto bolt, so with it in the receiver, the lower won't slide over it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now