Caina-Longbranch Limited Posted October 11, 2021 Report Share Posted October 11, 2021 Looking for M 79 40mm Grenade launcher receiver drawings that may be publicly available to fix defective "carbon fiber" M 79s made for us a while back before the manufacturer bailedWe have been able to finds production drawings for the 1911 (JM Browning Pattern) but not the M-79 to dateWe would also be interested in the 1911 slide drawings, Colt Pattern if available?The best way to contact is still our contact pagehttps://cainalongbranch.com/Contact_Us.phpThank you for your help Link to comment Share on other sites More sharing options...
BillyDixon Posted October 12, 2021 Report Share Posted October 12, 2021 is it legal under ITAR regs to export gun part tech. drawings out of u.s. with out export licence ? just wondering Link to comment Share on other sites More sharing options...
MG08 Posted October 12, 2021 Report Share Posted October 12, 2021 Not without State Dept approval. You cannot send Knights rail instructions outside the US without a export permit. Same applies to tactical training, reloading information etc. We ran into this in UAE , KSA and S. Africa. we were cautioned not to discuss even weapon performance. Link to comment Share on other sites More sharing options...
Caina-Longbranch Limited Posted October 12, 2021 Author Report Share Posted October 12, 2021 Not without State Dept approval. You cannot send Knights rail instructions outside the US without a export permit. Same applies to tactical training, reloading information etc. We ran into this in UAE , KSA and S. Africa. we were cautioned not to discuss even weapon performance.Good point This is for production in the US, so Question is resolved; however, good point We should all define what is publicly available and what is not also keeping in mind this a a 1950s design so goof question and worth asking so we are all on the right side of what we are doing This probably worth its own discussion to bring clarity to an important subject and give people peace of mind in the process Link to comment Share on other sites More sharing options...
StrangeRanger Posted October 12, 2021 Report Share Posted October 12, 2021 What about drawings published on the net?That pretty much end-runs ITAR Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now