Jump to content


Scope Mounts For BM59?

  • Please log in to reply
4 replies to this topic

#1 lake ogemaw

lake ogemaw

    New Member

  • Regular Group
  • 1 posts

Posted 18 September 2007 - 11:55 AM

Has anyone been able to find a scope mount that could be used on a BM59? `
  • 0

#2 bm59collector


    RKI Member

  • Regular Group
  • 188 posts
  • Gender:Male
  • Location:The Full Auto only state
  • Interests:Imperial German military steins

Posted 26 September 2007 - 10:49 AM

I tried to get a original Beretta mount 25 years ago from Reese, no luck - but they are out there. What I did was search for a mount that did not require any drilling and wound up purchasing a S&K mount and their rings (1"). You have to remove the rear sight & knobs since it uses the 'wings' to attach to. You will not be able to use the stripper clip feature, but it does make a pretty decent set-up. What you see is it installed on my BM62. Before purchasing, I made sure I had full return privileges in case I ran into a problem - a lot of companies make promises and can't deliver. This worked out great, I had to use a soft mallet to tap the base in, but that was normal per S&K. Being a dealer I remember getting some type of discount but I don't remember what it was.

I recommend that if you decide to go the route I did, give S&K a call and talk to them - the BM59 wasn't on their list, but they made a suggestion and it worked out fine - HTH





Edited by bm59collector, 26 September 2007 - 10:50 AM.

  • 0

#3 mikebaker1129


    Long Time RKI Member

  • Regular Group
  • 328 posts
  • Gender:Male

Posted 01 October 2007 - 07:31 PM

All I can say is WOW ! That is some sexy lumber on that 62!
  • 0

#4 gunner69skmc


    New Member

  • Regular Group
  • 7 posts

Posted 05 August 2018 - 06:14 PM

This is an old post,   but if you haven't gotten a scope mount yet here is the source.   M14.ca has a excellen, over bore, mount they offer.   It is their CASM GEN II  a new generation mount for the BM-59.   They are out of Canada but the service was reasonable and fast.   They have great installation information provided for the mount installation.   Hope this helps.

  • 0

#5 blfuller


    New Member

  • Regular Group
  • 4 posts

Posted 22 August 2018 - 03:47 PM

Classic Arms also has a steel one made by Sadlak.  I think it looks a little better than the M14.ca one.


Edited by blfuller, 22 August 2018 - 03:49 PM.

  • 0