DougStump Posted August 28, 2019 Report Share Posted August 28, 2019 Would there be any interest in a cheap (ABS plastic) 3D printed drum greaser? I can borrow a drum to measure, but if someone could give me the dimension it would be helpful. Depending what grease is used it might break down the ABS plastic over time, but you'll probably only need it once. If there is interest, and I can make it work, I would make them available for slightly over cost. The highest cost would be the postage! Also, how about a mag feed lip gauge? Anybody have a copy of the original drawings to get the exact dimensions? Link to comment Share on other sites More sharing options...
LSU Tiger Posted August 28, 2019 Report Share Posted August 28, 2019 I'd be interested in a mag lip gauge. Link to comment Share on other sites More sharing options...
cbmott Posted August 28, 2019 Report Share Posted August 28, 2019 I’d be interested in the greaser Link to comment Share on other sites More sharing options...
Autorotate Posted August 28, 2019 Report Share Posted August 28, 2019 I would also be interested in a mag lip gauge. Link to comment Share on other sites More sharing options...
Bridgeport28A1 Posted August 28, 2019 Report Share Posted August 28, 2019 Would there be any interest in a cheap (ABS plastic) 3D printed drum greaser? I can borrow a drum to measure, but if someone could give me the dimension it would be helpful. Depending what grease is used it might break down the ABS plastic over time, but you'll probably only need it once. If there is interest, and I can make it work, I would make them available for slightly over cost. The highest cost would be the postage. Also, how about a mag feed lip gauge? Anybody have a copy of the original drawings to get the exact dimensions? Most drawings are on NFAtoys http://www.nfatoys.com/tsmg/pdf/5564349.pdf Link to comment Share on other sites More sharing options...
Tiz Posted August 29, 2019 Report Share Posted August 29, 2019 As far as a drum greaser goes, it was very easy to machine one from aluminum bar stock just using the picture of one posted on this form. It took me less than an hour to make. Link to comment Share on other sites More sharing options...
laurencen Posted August 30, 2019 Report Share Posted August 30, 2019 (edited) couple years ago i printed a greaser, all it needs is a couple O rings and a grease zerk, anyone interested message me and cover postage, this is a link to the old post http://www.machinegunboards.com/forums/index.php?showtopic=19832&hl=%2Bdrum+%2Bgreaser&do=findComment&comment=172454 Edited August 30, 2019 by laurencen Link to comment Share on other sites More sharing options...
DougStump Posted August 31, 2019 Author Report Share Posted August 31, 2019 Laurence, Would you be willing to share the STL file? Link to comment Share on other sites More sharing options...
laurencen Posted September 1, 2019 Report Share Posted September 1, 2019 Sure would share the stl file, will try to post it when I get back to office Link to comment Share on other sites More sharing options...
Waldo Posted September 14, 2019 Report Share Posted September 14, 2019 I would also be interested in a drum greaser. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now