WTB: M3A1 Ejection-Cover-Pin and Threaded-Receiver-Insert.

[Blanksguy]

WTB:

1: M3A1 Ejection-Port-Cover mounting-pin (Note: This is slightly longer than the pin used on the M3 Grease Gun.).

 

2: M3/M3A1 Threaded Receiver Insert for front of receiver where barrel screws into. (Note: This can be a used part and still welded in the front of an old receiver section.).

 

Let me know what you have, condition (photo of the Threaded Receiver Insert), and price shipped to me at ZIP: 48706.

Regards, RichardS.

US Army, RET

E-Mail: Blanksguy2001@outlook.com

Edited July 5, 2022 by Blanksguy

[Blanksguy]

Still looking for these two Grease-Gun Parts..........any leads to find them will help.

TIA, RichardS

US Army, RET

E-Mail:  Blanksguy2001@outlook.com 

[Babyface Nelson]

Hello,

There is a gentleman on Gunbroker who sells quite a few M3/M3A1 GG parts.

You might want to inquire with him. His moniker is "what". His name is Brandon Hose.  Email:  rltw@att.net 

I've done business with him in the past and have been completely satisfied.

Good luck !!

"BF"

Edited April 24, 2023 by Babyface Nelson
add information

[Mojopin2010]

18 hours ago, StrangeRanger said:

That's probably as good a price as you're going to find on one in this market.

Have you checked out parts availability and costs? It may affect your decision. some stuff is hard to find and/or expensive

 

2 hours ago, colt21a said:

Mags are mags they all cost more today what else is new?parts what you need you want to rebuild it already?

very few break down.and never heard some disaster problems with Wilson.Unless the parts kit used was driven over by a Panther tank.

there is enough info out there to fill books. Oh wait they already did that also.

And if $14,000 is too much spend a few hundred for a full auto b.b. shooter.for wall hanger.you now can get pen and paper and write down all the pros and cons of spending $14 g or a few hundred, And if you never ever had one in life.

 

simple BUY IT!  

I have a parts kit that was to finish my Medea Corp shell, I will take picture of what I have over PM.

[BRMCII]

Need recoil guide rods and supporting parts if you have them for sale. Reply:  Bmg17a1@gmail.com