GaryKeim Posted September 26, 2018 Report Share Posted September 26, 2018 I took my m1918 to the range for the first time. The RO asked for my papers, which I didn't have on me. He relented and said it was OK to fire full-auto but only if he was there to hold my arm. He said it would rise and I'd hit the ceiling. I told him I wanted to start out with semi-auto and he walked away. I misread F as Full-Auto and pulled the trigger. A burst of 4 rounds resulted. He shut me down... mistake made, lesson learned. [Aside: they could have done a better job marking the fire selector switch from a usability standpoint.] The RO said the last round did hit the ceiling. Felt like a dope. When I inspected the target there were 9 holes and many of those were small. Is it possible the rounds fragmented? I was firing: PPU Rifle Line 30-06 Springfield For rifle M1 GarandFMJ 150 gr | 9,7 g What do you guys use? Link to comment Share on other sites More sharing options...
jim c 351 Posted September 26, 2018 Report Share Posted September 26, 2018 (edited) Gary,I shoot reloads.175 gr M72 match bullets45 gr 3031CCI primer."F" is semi. "A" is full.However, if your trigger pull is sensitive you may get a double when set on semi.Jim CPS are you banned for life?? Edited September 26, 2018 by jim c 351 Link to comment Share on other sites More sharing options...
fifthmdec Posted September 26, 2018 Report Share Posted September 26, 2018 Bummer man. It takes time to feel out the weapon, even though it is around 20 pounds loaded. It does climb, it catches the neophyte off balance. Had a NE Arms 1918A2 for a long time. It has a rate of fire reducer setting. I found out that helped the operator to get a feel for the rifle. Sounds like you have a 1918 model, semi and full... Lot of knowledgeable guys in the boards. Enjoy your purchase. Youll get the hang of it... Link to comment Share on other sites More sharing options...
Petroleum 1 Posted September 27, 2018 Report Share Posted September 27, 2018 Geez Gary thats a good way of wearing out your welcome Dont feel bad a few months back i was at the indoor range with my M1A1 blasting away. I asked the tough looking young kid (RO) if he could take my tele and get some video which he did an excellent job.As i finished the last mag i noticed the range mgr standing behind me drooling. I turned around and said hey i have some extra ammo would you guys like to fire a mag?? Sure !! so the range mgr fires off the first mag does a great job never fired a tommy before. The tough looking young kid gets up there and fires a full burst into the ceiling halfway down the range!! he finished the mag and as all the white ceiling sound insulation is drifting down he hands the tommy back to me and says...you have a real MANS gun here lol!! I said to the range mgr you would ban me for life if i did that!!! Vin Link to comment Share on other sites More sharing options...
GaryKeim Posted September 27, 2018 Author Report Share Posted September 27, 2018 (edited) The RO just shut me down for the day with the m1918... I was able to continue with other weapons. I understand that you can't make mistakes with this stuff in that environment. My main mistake was not having it on Safe in the first place. If I had, I would have seen F and A and realized it probably meant Fire and Auto. I've got to get better at that. It especially caught this newbie off-guard as I wasn't expecting it. I think the ammo I'm using, M1 Ball, is the proper ammo. Edited September 28, 2018 by GaryKeim Link to comment Share on other sites More sharing options...
jl7422 Posted September 28, 2018 Report Share Posted September 28, 2018 To your original question; M-1 ball is the correct ammo to use. I've used CMP surplus ammo in both semi and full auto BARs and it works fine. Link to comment Share on other sites More sharing options...
Grasshopper Posted September 28, 2018 Report Share Posted September 28, 2018 Hi Gary, I can't be helpful with ammo, but I do teach an NFA RO course at my local range. Since safety is our primary goal with shooting NFA firearms at our range, one of the many strong recommendations is that folks with new guns, guns new to them, or ammo new to the gun (especially with open bolt guns) that the shooter start with 1 round in the magazine. Then 2 rounds. Then 3 rounds until the shooter is more familiar with the firearm and the reliable function of the gun/ammo combination is confirmed. I have to do a better job however. After the last classroom session, one shooter loaded a Sten with lowpower ammo. It was the first time he had fired the subgun. Yes, you can see it coming. The gun ran away and dumped the magazine with 1 pull of the trigger. After shaking the adrenalin out of his shorts, we went back through a portion of the class and proceeded ahead. BTW, I wish I had a problem with a 1918 as I don't have one Enjoy,Grasshopper Link to comment Share on other sites More sharing options...
GaryKeim Posted September 28, 2018 Author Report Share Posted September 28, 2018 (edited) @jl7422: thanks... still wonder why there was more holes than rounds fired. Especially since one apparently hit the ceiling. @Grasshopper: great advice that I will employ. Love your dog! Reminds me of the lion from The Wizard of Oz. Edited September 28, 2018 by GaryKeim Link to comment Share on other sites More sharing options...
Petroleum 1 Posted September 28, 2018 Report Share Posted September 28, 2018 Recently i took delivery of a MP43. First time at the range i loaded 10 rounds and ran two mags in semi. Then two 10 round mags in full auto bursts. After i was comfy it was game on ha. Link to comment Share on other sites More sharing options...
jl7422 Posted September 28, 2018 Report Share Posted September 28, 2018 I have used the 1-2-3 round technique Grasshopper outlines above for as long as I can remember, No matter what style weapon or action; something new to me always gets that treatment the first time out. A lot less to go wrong and a lot easier to clear jams and potential problems. Link to comment Share on other sites More sharing options...
GaryKeim Posted September 29, 2018 Author Report Share Posted September 29, 2018 Thanks for your support, guys. I’ll be taking it to the range again this weekend with a plan in hand. Link to comment Share on other sites More sharing options...
GaryKeim Posted October 1, 2018 Author Report Share Posted October 1, 2018 (edited) Went back to the range with an off-duty range employee/friend. We executed the following shooting sequence: Semi-auto standing a) 1 rd. in mag 2 rds. in mag Full-Auto sitting with fore stock resting on table c) 1 rd. in mag d) 2 rds. in mag e) 3 rds. in mag My buddy did fine on (a) but on ( he mistakenly had it on A, even though we discussed this extensively! This scheme worked well as the barrel rose and his 2nd round hit the top of the target. Next time we'll move to Full-auto kneeling then standing. It's a blast to fire and was the star of the range. Edited October 1, 2018 by GaryKeim Link to comment Share on other sites More sharing options...
michaelkih Posted October 2, 2018 Report Share Posted October 2, 2018 I use the PPU that comes in the 500 round cans. Good stuff. Link to comment Share on other sites More sharing options...
GaryKeim Posted October 2, 2018 Author Report Share Posted October 2, 2018 Yes, I was told that PPU is considered very high quality. I believe the fragmentation I saw on the first attempt to fire it was caused by rounds hitting the ceiling or other hardware supporting the target. Everything was normal on the last visit. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now