Jump to content

M1 Ejector - Length


Recommended Posts

I ordered a replacement M1 ejector amongst a lot of small parts.

 

It was sent out promptly, and everything else fits and works, however, when the ejector screws in tight, it is a whole four turns too far into the receiver and will obviously stop the bolt moving.

 

When it is in a position to allow the bolt to move and is oriented correctly, the saver is .5" away from the side of the receiver.

 

It is "S" marked and has no milling marks, appearing original - is it an ejector for a different firearm, or am I doing something indescribably wrong?

 

qFpJsN1l.jpg

 

jFPGJEml.jpg

 

8wlNpBul.jpg

 

Thanks in advance.

Link to comment
Share on other sites

  • 2 weeks later...

I have the 2 Thompson ejector listings corrected now.
My people were surprised that we had sold over 30 of each one before it was mentioned that the listings were reversed.
If you received the wrong part please contact my Customer Service to have the ejector exchanged.
service@apexgunparts.com

Richard

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...