Well I was wondering what would happen if I were to try to fit a Thompson M1 kit on a semi receiver. I have been questioning it for quiet a while and I looked around a little bit unable to find a answer. I did see the other topic that sounded like it but I wasn't quiet sure. Well thanks in advance.
Question On Mixing Parts
Started by
Incomplete
, Sep 28 2003 08:20 PM
2 replies to this topic
#1
Incomplete
-
- Regular Group
-
- 65 posts
Member
- Location:Pennsylvania
Posted 28 September 2003 - 08:20 PM
#2
John Jr
-
- Regular Group
-
- 1956 posts
Long Time RKI Member
- Gender:Male
- Location:Mena, Arkansas, USA
- Interests:Plenty
Posted 28 September 2003 - 09:11 PM
You go to jail.
#3
full auto 45
-
- Board Benefactor
-
- 4934 posts
Respected Member
- Gender:Male
- Location:Looking over your shoulder right now
- Interests:Thompson's, Any Machinegun, Harley's and scuba diving. In that order.
Posted 28 September 2003 - 09:40 PM
Plus it won't fit.It's about 10/10000 to small and it's(semi) about a 1/8" longer than a full auto. And it would cost you about $10,000 on top of being someones prison bitch for 10 years. Save your bucks and get a real one. Trust me 
it's much more fun.
it's much more fun.
