Blanksguy Posted December 6, 2019 Report Share Posted December 6, 2019 Does anyone have a clear photo of the Barrel-Ratchet Rivet-Bucking-Bar measurements from the Grease-Gun "TM" that shows the measurements to make this tool (and possibly indicates the Heat-Treatment-RC) that they can either post here or e-mail to me (?). This would be the tool used to install new rivets (along with hammer and flat-punch) to hold the Barrel-Ratchet-Spring on the front of the magazine-well with two rivets. TIA, RichardSUS Army, RETBlanksguy2001@outlook.com Link to comment Share on other sites More sharing options...
Annihilator Posted December 7, 2019 Report Share Posted December 7, 2019 I had a support made by a friend. Will send you the plans http://www.machinegunboards.com/forums/index.php?showtopic=20825 Link to comment Share on other sites More sharing options...
Blanksguy Posted December 13, 2019 Author Report Share Posted December 13, 2019 Still looking for a copy of the drawing(s) out of the "Grease-Gun-TM" to make the M3/M3A1 Barrel-Ratchet-Bucking-Bar to have one (or more) made up by local machine-shop. Regards, RichardSUS Army, RETBlanksguy2001@outlook.com Link to comment Share on other sites More sharing options...
M17ap Posted December 14, 2019 Report Share Posted December 14, 2019 Rich , Check email. Info sent. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now