Annihilator Posted November 8, 2016 Report Share Posted November 8, 2016 Dear all i am about to finish my 1918 BAR project and badly need the dimensions of the WW1 flash hider Attached there is a pdf document/drawing with the dimensions needed Thanks for your help PierreBAR 1918.pdf Link to comment Share on other sites More sharing options...
RoscoeTurner Posted November 8, 2016 Report Share Posted November 8, 2016 I have one in a parts box, will send the dimensions later this morning if no one else beats me to it. Link to comment Share on other sites More sharing options...
OCM Posted November 8, 2016 Report Share Posted November 8, 2016 I'll get mine out of the safe, Mr. Turner probably can give better dimensions then I. OCM Link to comment Share on other sites More sharing options...
OCM Posted November 8, 2016 Report Share Posted November 8, 2016 (edited) No expert on this, suggest you compare with Roscoe maybe. Give you a start. I don't have smithing tools to measure etc. Metric: A=95B=22C=19D=85 Hole is 10 from base, 4 wide about 2 deep. Edited November 8, 2016 by OCM Link to comment Share on other sites More sharing options...
Annihilator Posted November 8, 2016 Author Report Share Posted November 8, 2016 (edited) Great! Many thanks, for these valuable informations ! Pierre Edited November 8, 2016 by Annihilator Link to comment Share on other sites More sharing options...
RoscoeTurner Posted November 8, 2016 Report Share Posted November 8, 2016 9.4 cm2.3 cm2.0 cm8.1 cm Parkerized finish, no wrench hole. Link to comment Share on other sites More sharing options...
Annihilator Posted November 9, 2016 Author Report Share Posted November 9, 2016 Many thanks to both of you ! Pierre Link to comment Share on other sites More sharing options...
Mongo Posted November 9, 2016 Report Share Posted November 9, 2016 (edited) Here is the original 1918 flash hider drawing with all the measurements you need to reproduce it. Edited November 9, 2016 by Mongo Link to comment Share on other sites More sharing options...
Annihilator Posted November 9, 2016 Author Report Share Posted November 9, 2016 Great, many thanks to you all Link to comment Share on other sites More sharing options...
Annihilator Posted November 9, 2016 Author Report Share Posted November 9, 2016 Here you have some pictures Link to comment Share on other sites More sharing options...
johnsonlmg41 Posted December 4, 2016 Report Share Posted December 4, 2016 BMG parts was selling repro units. Don't know if they still have them or not? I'd go that route before I'd make a one off. Link to comment Share on other sites More sharing options...
Annihilator Posted December 5, 2016 Author Report Share Posted December 5, 2016 Thanks, but it's already done. Still has to be blued. Link to comment Share on other sites More sharing options...
Atllaw Posted September 26, 2019 Report Share Posted September 26, 2019 Sorry to resurrect this thread, but curious about something. Does the original drawing show a hole? I just received a 1918 with a flash hider that has no hole for a wrench. Not to say it is original, but curious. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now