I have 2 skeleton stocks but only one snaps into place. The other will not slide completely into the receiver. In fact, it hardly gets started. Before I start hammering and filing, could someone with experience fitting these to specific guns offer some helpful tips?
I have attached pictures to help demonstrate the problem.
I think the tab on the stock which does not fit is too wide to slide into the slot in the receiver. But if you look at the first picture (the sideview of both stocks), the one that fits is slightly angled backwards at the top of the "O" and the tab at the bottom has a slightly large gap between the stock and the tab. Not sure what steps I should try first. Does anyone have a suggested workflow? Or other considerations I have not mentioned yet?
Thanks in advance.