Jump to content

- - - - -

1/2 Hanger From Kahr

  • Please log in to reply
No replies to this topic

#1 deerslayer


    Respected Member

  • Board Benefactor
  • 2377 posts
  • Location:North Iowa

Posted 17 January 2004 - 07:41 PM

Bought a new 1/2 inch hanger from Kahr for a project and didn't want to butcher any valuable tsmg parts. Going to add a piece to the middle to make the front grip extend about an inch and a half further to the front to see if the proportion looks better for the 16 inch barrel 1927.

Anyway, I thought the hanger looked very good. Nicely made. Compared favorablably to an original ww2 production piece. Only very one small complaint, the threaded hole was a little difficult to get the bolt started into. But once I screwed in in from the top things worked well.

I haven't put it on a gun yet, it was snug fitting as I tried sticking it into a receiver front so at least it won't rattle around. I was kind of afraid to tap it on as it might just resist coming back out.

Just thought I give a product report if any of you are considering the change to a 1/2 inch hanger.

  • 0