Jump to content


Photo
- - - - -

Spring Lenght Specs For Xxx Mags


  • Please log in to reply
No replies to this topic

#1 JTinIN

JTinIN

    Long Time RKI Member

  • Board Benefactor
  • 207 posts
  • Gender:Male
  • Location:Indiana
  • Interests:Machine guns and Flintlocks

Posted 21 November 2004 - 10:15 PM

Just got done cleaning 15 Thomson XXX mags and had a few questions:

1: What is the nominal and minium lenght for USGI 30 rnd Thomson mags?
(Most were 12.5 to 13 inches, with three being 12 to 12.5 and one at 11+)

2: Any differences between Seymor and CD followers?
(missed a couple of CD in the larger batch of Seymon and dump them all into the slovents together .... tricholor then mineral sprits with 7% ATF works week with some wiping and brushing).

3: Is there a correct / better way to put in the mag sprinc?
(Many, but not all, had the spring wire end on the bottom, pointing towards where the floor plate enters).

4: Have not been able to order the Tech manuals on CD (slow connection) but besides that CD and American Thunder, what reference books should I be getting (old questions ;-).

Edited by JTinIN, 22 November 2004 - 01:11 AM.

  • 0