Wolf Steel Case
Posted 31 January 2005 - 09:51 PM
Posted 31 January 2005 - 10:12 PM
What I saved in coins was more than spent on repairs.
I'm a "once did, never again guy" sorry.
Posted 31 January 2005 - 10:22 PM
Posted 31 January 2005 - 10:42 PM
I like the .45 in either lacquer or polymer coating. Runs well in both the Savage 1928A1 and in the M10.
I swore by the 9mm lacquer coated, but the latest 9mm with the polymer coating has been inconsistent; too much flash out the ejection port, sometime LOTS of burning powder ejected.
Some light loads as well; Not a good thing in f/a.
I think I may pass on any more 9mm, but will stick with the .45.
Posted 01 February 2005 - 02:30 AM
It just scares me to shoot Wolf after I have had problems with it the past. I don't mind shooting garbage in the sten or Uzi as replacement parts are cheap. Not in the 28 or 21 however.
Shooting it in the Kimber handguns is out of the question as it starts to jam after around 50 - 60 rounds. Slide will not go home all the way unless you push on the rear of the slide.
Will not feed in the Robinson arms 96 top feed. Jams from the get go!
I have not tried the new coating however....
Posted 01 February 2005 - 10:24 PM
Posted 02 February 2005 - 08:12 AM
Don't you mean "Forever hold your piece?" (Until they take it from your cold dead hands).