Jump to content


Photo
- - - - -

Newbie Questions--please Be Patient With Me


  • Please log in to reply
2 replies to this topic

#1 Ltcboy

Ltcboy

    Member

  • Regular Group
  • 83 posts
  • Gender:Male

Posted 02 October 2003 - 04:15 PM

Can anybody tell me how you go about removing the Cutts compensator from the barrel ? I know that you have to remove the pin, but is the pin beveled? I was trying to pound it out with a punch and -no dice. Should I heat it up? Also is it necassary to remove the foregrip mount to replce the old barrel with a new one? If it is -how do you remove it from the reciever? Is there anybody out there that would allow me to use a barrel wrench? I will pay you for its use and I will pay for the shipping to and from my house. Any help would be kindly appreciated.


Thanks--

MIke
  • 0

#2 PK.

PK.

    Technical Expert

  • Board Benefactor
  • 1567 posts
  • Gender:Male
  • Location:CO, USA
  • Interests:Full time gunsmith who loves Thompsons, 35+ years experience.

Posted 02 October 2003 - 05:26 PM

The pin should come out with reasonable force and a proper size punch. After the pin is removed, the Cutts should unscrew. The Grip Mount is retained by the barrel, which must be removed first.


  • 0

#3 JimFromFL

JimFromFL

    Long Time RKI Member

  • Regular Group
  • 1877 posts
  • Gender:Male
  • Location:Florida

Posted 02 October 2003 - 09:13 PM

You may want to try standing Tommy on the muzzle within a cup or bucket of lubricant and see if this helps.
Chances are though that its such a tight fit that any lubricant may not be able to seep in.


  • 0