Richardson 28/27 Bolt Handles
Posted 07 October 2005 - 09:05 PM
Very fine detailing, and craftsmanship. Doug has put time in these!
Posted 08 October 2005 - 02:57 PM
Posted 08 October 2005 - 10:25 PM
Posted 08 October 2005 - 11:16 PM
Posted 09 October 2005 - 12:58 PM
Just want to say we are accepting Pay Pal now for Doug's items by adding an extra 5%.
The cost for the Bolt Handle plus S&H plus 5% is $58.80.
A lot of you seem to prefer a prompt transaction.
Be sure to pay to: BahiaLaguna@mail.com
Posted 09 October 2005 - 08:53 PM
Posted 11 October 2005 - 09:12 AM
Posted 11 October 2005 - 10:37 PM
LOL, I agree!
They would look far nicer in the gun.
I figured I would shoot the pics in full to give the details of its entire appearance.
I tend to keep the 27 a little on the wet side after cleaning, perhaps a few drops of oil once I've run a few hundred rounds.
I keep my 1911's a little wetter while shooting, due to tighter tolerances.
Posted 12 October 2005 - 10:59 AM
I tend to use about seven drops of light oil on my 1911's, two on barrel with slide locked back, ocasionaly one on the disconector, a pair on each grove in slide, close action and one on barrel hood, cycle a couple of time; never failed. Always needed to keep my W/H semi about how the militay M-16 maual defined heavy, enough lube that you could move it with your finger before I got Mr. Ricardsons miraculus cocking handle. I knew the elogegated oval and the width of the grove for the firing pin were the problems, just didn't want to pay Khar for replacements. Some bad stories of their early production, and not just on the board. Had just enough Hoppes light oil to make the parts glisten to prevent rust before I put it in storage a month prior. 450 - 500 rounds nary a hickup.
Posted 18 October 2005 - 08:20 AM