Any information regarding smoothing, lightening, tuning, adjusting the extremely heavy trigger pull on the Kahr Thompsons?
Any help/advice would be appreciated - Thanks - feinc
Kahr Thompson Triggers ?
Started by
feinc
, Dec 18 2003 12:57 PM
2 replies to this topic
#1
feinc
-
- Regular Group
-
- 1 posts
New Member
- Location:Colorado
- Interests:ffl & Officer
Posted 18 December 2003 - 12:57 PM
#2
Sgt
-
- Board Benefactor
-
- 2050 posts
Long Time RKI Member
- Gender:Male
- Location:Eastern TN
- Interests:Militaria, Chess, Tools, Sherlock Holmes, Printmaking, UFOs, Ghosts, Electronics, Comic Books, Long walks in the rain, with my Savage 1928a1. (just kidding on the last one; it doesn't have to be raining) -- Ralph
Posted 18 December 2003 - 04:16 PM
feinc--
Mine has a heavy action too. I'd like to know the answer to this one also.
Mine has a heavy action too. I'd like to know the answer to this one also.
#3
PK.
-
- Board Benefactor
-
- 1590 posts
Technical Expert
- Gender:Male
- Location:CO, USA
- Interests:Full time gunsmith who loves Thompson's, 46+ years experience.
Posted 18 December 2003 - 04:53 PM
Some folks say “heavy” when they mean “creepy”. I don’t know if this is the case here of not.
Through careful balancing of spring tensions and attention to engaging surface finish, the pull weight can be reduced (lbs. required to release) and smoothed, but this design will not allow the let off to be “crisp”.
I liken them to shooting DA revolvers.
Through careful balancing of spring tensions and attention to engaging surface finish, the pull weight can be reduced (lbs. required to release) and smoothed, but this design will not allow the let off to be “crisp”.
I liken them to shooting DA revolvers.
