timkel Posted March 17 Report Share Posted March 17 I have only found reference to surplus loaders that don't work very well. Link to comment Share on other sites More sharing options...
Rekraps Posted March 19 Report Share Posted March 19 I have never seen one for sale or otherwise, however it seems logical that Russia would have done so given the number of PPS's manufactured. Have you tried the PPSH loader? Link to comment Share on other sites More sharing options...
StrangeRanger Posted March 19 Report Share Posted March 19 PPSh41 = double stack single feed, loader slides on to two horizontal ribs just below the feed lips PPS43 = double stack double feed, no ribs present The PPS43 mag shape is similar to an Uzi or Beretta mag but considerably longer front to rear, I don't know about width. It's possible that you could cut and weld one of these: https://www.robertrtg.com/mag-loader-uzi-9mm-or-45acp Link to comment Share on other sites More sharing options...
timkel Posted March 19 Author Report Share Posted March 19 Thanks for the suggestions. I think I will try to fabricate one. Link to comment Share on other sites More sharing options...
Rekraps Posted March 21 Report Share Posted March 21 It just seems odd that a speed loader was not made.... Link to comment Share on other sites More sharing options...
StrangeRanger Posted March 21 Report Share Posted March 21 For double-stack double-feed mags loaders are a convenience not a necessity like they are for double-stack single-feed ones Link to comment Share on other sites More sharing options...
timkel Posted March 26 Author Report Share Posted March 26 I tried modifying the RTG loader. Spit the back and bent the tabs to accommodate the deeper mag. It works better then I expected on a PPS43 mag. I will have to test further to see how it holds up to use. Link to comment Share on other sites More sharing options...
StrangeRanger Posted March 26 Report Share Posted March 26 You might want to weld a U shape across the back to stabilize/strengthen it Link to comment Share on other sites More sharing options...
timkel Posted March 26 Author Report Share Posted March 26 I don't want to over think this job. Good enough is perfect. If needed I'll box the back in. Link to comment Share on other sites More sharing options...
Rekraps Posted April 17 Report Share Posted April 17 And… does it work fine? Link to comment Share on other sites More sharing options...
timkel Posted April 18 Author Report Share Posted April 18 11 hours ago, Rekraps said: And… does it work fine? Yes, it works fine. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now