zavrit Posted August 16 Report Share Posted August 16 I have a friend in Europe who will have a vertical grip made from wood, but he's looking for actual dimensions instead of guessing. He made a 3D print for his Thompson, but as mentioned he would like actual dimensions to check his work. By chance, is there a drawing somewhere? Or, if possible, can someone take some measurements? Anything is better than nothing and any assistance is greatly appreciated! Photo of his Thompson. Thank you! Link to comment Share on other sites More sharing options...
bob241 Posted August 27 Report Share Posted August 27 According to recon bob posting several years ago, who had the prints for the grip, nothing was shown except the angle of the vertical hole, all grips were hand finished on a belt sander, after being sawed out around a pattern. attached is a good picture of a original grip. Link to comment Share on other sites More sharing options...
deerslayer Posted August 28 Report Share Posted August 28 Message me his email if you wish for help Link to comment Share on other sites More sharing options...
zavrit Posted August 31 Author Report Share Posted August 31 I appreciate everyone's replies. He found the measurements he was looking and is all set. Thanks again. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now