madmax1299

Looking for a bolt in pretty much any condition. Thanks!

Looking for a high condition all matching kit. Thanks!

I don’t but wouldn’t it be hard to keep straight? They don’t seem too expansive I could get one.

I know a press would be best, but I don't have immediate access to one any of you know whats best outside of freehanding drilling? thanks!

So i got a new dummy tube and and magwell i have does not fit. I would like to mold it as best I can to the dummy tube without damaging it. The only idea i had atm was to get a plastic mallet, but the magwell on he dummy receiver and hit it into place as im not to concerned with the dummy receiver getting a little beat up. thanks for any advice!

Title says it all. Have a new dummy tube I’m trying to put a sight on but want to keep as much finish as possible. I see two little “nub” where it was previously attached. Not sure if anyone had any ideas, thanks!

And logic on when they would stamp vs electro pencil?

So my barrel thread protector (BTP) has elector pencil of the last 3 serial numbers of the mp40. I can’t image that was the standard method for this early in the war but I could be wrong, thanks!

Ive heard it possible to straighten and reflair the pins to get it out and back in but you need special "tools". I would really want to use the pin thats already in it again.

Anyone have an suggestions for getting the pin that holds the resting bar in and out? I know it’s a cardinal sin, but I want to install an original resting bar I have (so I don’t want to notch it) Thanks for any help!

Can I get pictures with this? I need to put a resting part on my MP40 but i want to do it right getting the pin in and out, thanks!

How would you go about fixing this bren stock? I have no skill in wood working so I was hoping to get suggestions on what to do and what glue to get, thanks! bren questions - Bren Light Machine Gun & Lewis Gun Message Board - MachineGunBoards.com Forums

To me its cool to have a kit that matches since I dont have the funds to purchase a registered one. Price wise they usually go for quite a bit more, but im more interested in the historic aspect that all those parts once made a MP40 that was used in that configuration. Just my 2 cents maybe it does not matter to most. Maybe one day ill stumble upon one (maybe in this forum) that is matching that I can afford, but until then parts kits is how I enjoy the MP40.

So I have a BNZ 42 kit and it did not have a number half moon. I haven’t seen any other kits that did have numbers from steyer until yesterday and now I don’t know if mine would or wouldn’t have been numbered, thanks for any information!

Do you have any excellent stocks with lowers that you will be listing/ i can get form you now?