rabbit

My son got ahold of Dan, heisgoing to send the thompson to him to get it fixed and the bolt hold open mod. he is wanting to sbr it later as well.Hebought a new semiauto only 1919 as well for his WW2 collection and its been a blast shooting it.He wants to put spade grips on it. the slide on shoulder stock was very uncomfortable.

Got the ez spring kit in it and its binding up on the magazine now. bolt gets stuck on the top of the magazine and will go forward, just needs pushed. also, noticed a disconnecter popping out and rotating on the pin that holds it in, i had to flip it back in place.is it supposed to do that? I will have my son get ahold of dan.I have bad arthritis and dont really tinker on things these days but do enjoy the time. thanks forall the help.im sure itll run again.

My son recently bought a new thompson and brought it over and we had some issues. that disassembly button gets stuck and its hard to get it unstuck.its scored up the inside of the lower good from using a screw driver in the groove to get at that button the charging knob is so small its hard to operate and Ive read that he can get the ez spring kit that will fix that and also the bolt hold open mod to make sliding the drums in there much easier. First shots, it had 3 out of 50 ftf. in the drum and 1 out of the 20 stick magazine. the one ftf shoved the bullet back in the case after getting hung up.We had fun shooting it. I apologize if its been covered here before. its the steel receiver version. 1927 chicago typewriter. semi auto. im not mechanically inclined these days much so it would need sent off.Thanks for any help and suggestions.