Bender Posted September 9, 2016 Report Share Posted September 9, 2016 Now I've been noticing that my pivot plate seems to be pushing itself out of the receiver. It can only go so far, to the point that the safety lever section stops it, but it's a little annoying that it doesn't stay flush pressed up against the receiver anymore. Anyone ever see this? I've removed it and reinstalled it maybe like 6 times in the past few months. Is this normal that is pushes itself out, or is this part worn now too? Link to comment Share on other sites More sharing options...
Hang-Fire Posted September 18, 2016 Report Share Posted September 18, 2016 I recently dealt with this on mine. The safety lever is what keeps the pivot plate held against the receiver. My safety lever would push into the receiver farther than it should allowing my pivot plate to drift outward during firing. I added a small pin to the safety shaft to create a limiter for it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now