huggytree Posted July 29, 2018 Report Share Posted July 29, 2018 curious id any of you have a slab side mag well in good condition (no pitting)...its easier to replace mine than to try to rework it as its been drilled out for a larger pin and i believe a bit misshapen from that experiment making it a bit loose too... thanks in advanceDave Link to comment Share on other sites More sharing options...
TSMGguy Posted July 30, 2018 Report Share Posted July 30, 2018 The ribbed well was far more common, and will probably be easier to find. If the gun was made in 1941 or later, it likely left the factory with a ribbed well. Link to comment Share on other sites More sharing options...
huggytree Posted August 1, 2018 Author Report Share Posted August 1, 2018 (edited) gun is 1940.....i have possibly found one in Holland. if anyone has one im still looking at this point Edited August 1, 2018 by huggytree Link to comment Share on other sites More sharing options...
Normal1959 Posted August 1, 2018 Report Share Posted August 1, 2018 Have you considered the MP38 magwell? I bought a couple myself just because i like the durability.Eric Link to comment Share on other sites More sharing options...
M17ap Posted August 2, 2018 Report Share Posted August 2, 2018 Mag housings are not interchangeable. The rings are different as are the receivers. 40’s only fit 40’s and the same for 38’s unless you want to cut rings and weld on new ones. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now