ttolley Posted April 11, 2015 Report Share Posted April 11, 2015 I have lost 2 firing pins. I replaced my original with one from http://www.keystonearms.com, a titanium Reising firing pin manufactured by Christies Products. The end broke off after about 200-300 rounds. Has anyone else had firing pin problems with their M 50's? It doesn't seem reasonable that a titanium pin would break off at all, much less than after 200 or so rounds. The pin was lubercated and was not jamming at all. The pin was also hitting the center of my bullet primers. I am at a loss here. A picture of the break is attached.Tom T. Link to comment Share on other sites More sharing options...
n64atlas Posted April 11, 2015 Report Share Posted April 11, 2015 (edited) The pins are known to break. Searched this form for that topic. I believe there is a fix: http://www.machinegunboards.com/forums/index.php?showtopic=8854&hl=%2Breising+%2Bfiring Edited April 11, 2015 by n64atlas Link to comment Share on other sites More sharing options...
ttolley Posted April 12, 2015 Author Report Share Posted April 12, 2015 This makes alot of sence all around. I will give it a try. Link to comment Share on other sites More sharing options...
smkummer Posted April 16, 2015 Report Share Posted April 16, 2015 Yes, I can confirm if you make your Reising a floating pin it will last a long long time. I must be 5-6000 rounds on my last pin. Link to comment Share on other sites More sharing options...
Grasshopper Posted June 12, 2015 Report Share Posted June 12, 2015 Hi, Just thinking out loud here. The inertial firing pin or floating firing pin seems to work really well. Might it be possible that the firing pins are supposed to be that way and the "replacement" firing pin was to be fitted to a particular gun? In other words, pins were left a bit long to be shortened on installation? I've been in mechanical production for 30+ years and I am amazed at what goes on with production when the guy that designed the stuff is sitting 150' away! Again just a thought. I'd best dig out the Model 50 and start a spring tune-up and firing pin filing Good Luck, Grasshopper Link to comment Share on other sites More sharing options...
doc280 Posted June 15, 2015 Report Share Posted June 15, 2015 The firing pin spring is made of beryllium copper and is noncorrosive. Nice thing to have when using corrosive ammo, but beryllium copper springs loose their tensile strength more quickly than steel springs. My opinion is to replace firing pin spring, with a modern spring. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now